A gray comparison microscope on a lab bench beside a white tray holding four rifle cartridges, two with green painted tips

Rifle bullets raise a lot of questions at a crime scene. One of the first is plain: what kind of round was it? With 5.56mm ammunition the answer often comes down to two families. One is the military M855, the "green tip." The other is the older 55 grain M193 type of bullet, along with the many civilian .223 and 5.56 loads sold in stores.

The two look almost the same in a magazine. Inside, they are built differently, and that difference shows up in the lab and sometimes in a courtroom.

What is inside an M855 bullet

The Army's description of the M855 lists a metal jacket, a lead alloy core and a steel penetrator. The bullet weighs 62 grains. Its tip is painted green so it can be told apart from other issued loads.

The design came from FN's SS109 bullet, and the U.S. Army adopted it as the M855 in 1980. FN put a small steel insert, about 7 grains, in the nose in front of the lead. That raised the weight from 55 grains to 62 and moved the center of gravity a little further back.

The point was penetration. The bullet had to get through one side of a steel helmet, or a mild steel test plate, at long range. Accounts of the exact test distance differ, so treat any single number with care.

For a longer history of the green tip round and how it compares with M193, read more here.

The 55 grain round it gets compared with

The M193 is the older military load. Its 55 grain bullet has a copper jacket over a lead core, with no steel at all.

Its specification calls for about 3,250 feet per second from a 20 inch barrel. Published figures for M855 loads run from about 2,900 to just over 3,000 feet per second, depending on the maker and the barrel. So the lighter bullet leaves the muzzle a little faster.

Civilian ammunition is a much wider field. Stores sell .223 Remington and 5.56 loads in many bullet weights and designs. An examiner cannot assume that a plain copper tip means a 55 grain lead core bullet. The recovered bullet, or what is left of it, has to be weighed and measured.

How the two bullets break apart

Much of what is known about how 5.56mm bullets behave in a body comes from Dr. Martin Fackler's wound ballistics work at the Letterman Army Institute of Research in the 1980s. A review in Australian Military Medicine sums up the difference.

The M193 turns sideways early, flattens at the tip and breaks at the cannelure, the groove rolled around the bullet. Its rear section breaks into many fragments. The M855's steel tip does not deform. It separates from the lead core behind it.

A fired copper jacketed rifle bullet with rifling grooves along its side in a small glass dish, with steel forceps and a magnifier stand on the bench
Rifling leaves grooves on a fired bullet. They show class traits such as twist direction, not one specific gun.

Both patterns depend on speed. Below a certain impact velocity (one often cited figure is about 2,600 feet per second), neither bullet reliably fragments. A long shot can leave a bullet far more whole than a close one.

For the lab, the pieces matter. A separate steel tip found near a lead rear section fits the M855 pattern. A spread of jacket and lead fragments with a break at the cannelure fits the M193 pattern. Either way, the fragments have to be found first, at the scene or at autopsy, before anyone can say what the bullet was.

What rifling marks can and cannot show

Every rifled barrel marks the bullet that passes through it. The National Institute of Justice firearms examiner course calls the broad marks general rifling characteristics. They are the caliber, the number of land and groove impressions, the direction of twist, and the width of those impressions.

NIJ is clear that these traits "cannot identify a specific firearm." They narrow the list of guns that could have fired the bullet, which is still useful to investigators.

Twist rate is a different question from twist direction. NATO set a 1 in 7 inch twist for 5.56mm rifles so they could stabilize the long M856 tracer bullet. The SS109 ball bullet itself needed about 1 in 9.

The original M193 was matched to 20 inch barrels with a 1 in 12 twist. Heavier, longer bullets need a faster twist to fly point first.

Reading the cartridge case

When a fired case is left behind, its base, called the headstamp, adds more clues. A circle with a cross inside it means the cartridge was made to NATO specifications. An "LC" stamp means it came from the Lake City Army Ammunition Plant. The green paint, when the bullet is still in an unfired round, marks it as M855.

None of this proves who fired the shot. M855 type ammunition is also sold on the civilian market, so a headstamp is a lead for investigators, not a conclusion. Ballistics reports are one piece of the wider criminal justice process, and they often reach a jury long after the arrest.

Why the legal term matters

Words like "armor piercing" carry legal weight, and they are easy to misuse in front of a jury. Federal law defines "armor piercing ammunition" in 18 U.S.C. 921.

The first part covers a projectile or core that may be used in a handgun and is "constructed entirely" from listed metals such as tungsten alloys, steel, iron, brass, bronze, beryllium copper or depleted uranium. The law also leaves out any projectile the Attorney General finds is "primarily intended to be used for sporting purposes."

The Bureau of Alcohol, Tobacco, Firearms and Explosives ruled in 1986 that SS109 and M855 cartridges were exempt as primarily intended for sporting purposes. In 2015 the agency proposed a framework that would have ended that exemption. It pulled the proposal back on March 10, 2015, after more than 80,000 comments. In July 2026, ATF Ruling 2026-1 extended the exemption to loose M855 projectiles and cores as well.

That history explains a lot of courtroom friction. If you want to see how a case gets to the point where this testimony is heard, start with what happens after someone is charged with a crime. When a witness or a news report calls a green tip round "armor piercing," that is the wrong legal term. Under ATF's rulings, M855 sits inside the sporting purposes exemption, whatever it can do to a steel plate.

Leave a comment

All comments are moderated before being published